This page is part of the Draft OpenRaster specification.
Status: Proposed Extension (currently unimplemented?)
Note: this is an early draft of the specification, do not take anything on this page for granted, pretty much everything is open for discussion.
As a standard extension, outside baseline but defined in the standard schema, OpenRaster layers stacks should be able to contain parameterised filters which themselves might contain sub-stacks. This document shows how the extension would be integrated into baseline OpenRaster
stack.xml syntax, describes the additional elements and attributes, and lists the available filters.
<stack> <stack> <filter name="invert" type="invert" /> <!-- layers --> </stack> <!-- ... layers ... --> <filter name="filter1" type="standard:gaussianblur"> <params> <param name="radius">10</param> </params> <stack> <layer name="mask2" src="data/mask2.data" composite-op="svg:src-over" /> <layer name="mask1" src="data/mask1.png" /> </stack> </filter> <!-- ... more layers ... --> </stack>
TODO: define how flters are to be applied. Presumably to just the layers inside the nested
<stack/> element? If so, how is the result to be composited onto the results of the layers below?
This element defines a layer which instead of containing pixel data, applies a filter onto the composited result of the layers below it in the stack. The attributes are:
type": the type of the filter. Type names make use of namespaces, they must have the following form: "namespace:name". Three namespaces are defined:
* "standard": for the list of filters and the associated mathematics, see the relevant OpenRaster specification * "composite": composite filter are filters which are a composition of a list of standard filters. The name must be the name of a filter defined in the same file. * "application": non-standard filters; the name is formed as followed "application:filtername". For example, for an application called MyGraphApp, the full name is "application:MyGraphApp:MyFilter". Use of such a type of filter prevents the file from being a Full Baseline OpenRaster file; however use of the "`output`" attribute defined below allows the file to be conformant to the Viewing Baseline.
output": the file name of the data of the filter output, this attribute is only needed when the type of the filter is of the "application" namespace, and if the user wants to create a Viewing Baseline layer stack.
This element is used to describe the parameters used for a filter layer. The standard filters each have a defined list of parameters, defined permissible values. Attributes:
version": correspond to the version of the filter, either the version of the filter specification for standard filter, or any number defined by the application for application-specific filters.
Description of the attributes:
name": the name of the parameter. The parameter's value is formed by the content of the
For "composite" filters, the params element allows variables to be defined which are then used to parameterise each contained filter. For example, consider a composite function composed of "standard:blur" filter with the parameter "radius" applied with a "standard:invert" filter. It is defined as follows in the composite section:
<compositefilter name="blurinvert" > <filter name="blur"> <params> <param name="radius"> @R@ </param> </params> </filter> <filter name="invert" /> </compositefilter>
Then the usage would be:
<filter name="composite:blurinvert" > <params> <param name="R">10</param> </params> </filter>
TODO: reconsider this, is it useful ? it just come out of my mind that is the only usefull use of parameters for composite filter, but if it's useless, lets not allow any parameters for them !
The mathematics behind each filter is described in the SVG 1.1 Specification, and each filter accepts the same parameters.
OpenRaster files may use filters not described in this document, in which case the file won't be valid for interoperability, unless the result of the operation is also available (see the
output attribute above).